#Dolphin emulator for mac how to
#Dolphin emulator for mac download zip
#Dolphin emulator for mac install

Restore the NuGet dependencies by running: nuget restore.) and enter the folder with the source code. Verify that you can run nuget from your favourite terminal. You should follow the section for nuget.exe. You should have a warning mentioning restoring your packages.Open the NuGet manager via Tools > NuGet Package Manager > Package Manager Settings.

Open Visual Studio Community and open the solution file ( BetterJoy.sln).

#Dolphin emulator for mac download zip

Get the code project via Git or by using the Download ZIP button.

#Dolphin emulator for mac install

If you didn't already, install Visual Studio Community 2019 via.Click on it and a 'Remove' button will be revealed.Under the first category 'Mouse, keyboard, & pen', there should be the pro controller.Go into 'Bluetooth and other devices settings'.Plug the controller into your computer.To reconnect - press any button on your controller. To disconnect the controller - hold the home button (or capture button) down for 2 seconds (or press the sync button).Search for it in your bluetooth settings and pair normally.Hold down the small button (sync) on the top of the controller for 5 seconds - this puts the controller into broadcasting mode.Connecting and Disconnecting the Controller Bluetooth Mode

#Dolphin emulator for mac how to

As of version 3, you can use the pro controller and Joycons as normal xbox controllers on your PC - try it with Steam!Ĭheck out the wiki! There, you'll find all sorts of goodness such as the changelog, description of app settings, the FAQ and Problems page, and info on how to make BetterJoy work with Steam better.

Turn rumble up to 70-80% if you want rumble.

This is no longer required as of version 3

If you don't want to do this for some reason, just have one input profile set up with Wii U Gamepad as the controller and enable 'Also use for buttons/axes' under GamePad motion source.

Go into Input Settings, choose XInput as a source and assign buttons normally.

If using Joycons, CemuHook will detect two controllers - each will give all buttons, but choosing one over the other just chooses preference for which hand to use for gyro controls.

Start Cemu and ensure CemuHook has the controller selected.

Run as Administrator if your keyboard/mouse button mappings don't work.

Run Drivers/ViGEmBus_Setup_1.16.116.exe.

Read the READMEs (they're there for a reason!).

I think this project was responsible for both software jobs I landed so far, so I am quite proud of it. It's been quite a wild ride, with nearly 590k (!!) official download on GitHub and probably many more through the nightlies. Thank you for your patience in that regard too! I don't have too much time to work on this project, but I will try to fix bugs when and if they arise. I started writing this project a while back and have since then learnt a lot more about programming and software development in general.

Thank you for using my software and all the constructive feedback I've been getting about it. If anyone would like to donate (for whatever reason), you can do so here. It also allows using the gyro to control your mouse and remap the special buttons (SL, SR, Capture) to key bindings of your choice. Allows the Nintendo Switch Pro Controller, Joycons, and Switch SNES controller to be used with Cemu using Cemuhook, Citra, Dolphin, Yuzu, and system-wide with generic XInput support.